setup1.JPG

Watch The Video For Step By Step Instructions

Installation Instructions

Choose your desired spacer size from the nested spacer set. This is the space you will have between each panel. We recommend 1” spacer, but this is completely up to you.  

  1. Layout your desired pattern on the floor.

  2. Take a photo(s) to reference throughout the install.

  3. Measure the total size of the design to ensure fit on your wall space.

  4. Decide a starting point to place the first panel on the wall, we recommend bottom to top.

  5. Peel the backing liner of the panel (make sure not to peel off the adhesive).

  6. Begin to place the first panel on the wall, use a level to ensure the design is straight before pressing firmly and evenly around the panel.

  7. Peel the backing off the second panel and place the included spacer on the top corner of the first panel in between your second panel to create consistent spacing between all panels.

  8. Continue to peel and place panels, utilizing the spacer and following your photo of the design you created on the floor as your roadmap for installation.

  9. Check your progress against reference photos until the design is complete.

  10. If you make a mistake along the way, peel the panel from the wall, from one of its corners, at a hard angle as quickly as possible and reset it in the correct position.

  11. Take a final photo of your Acoust-Hex design once you’ve completed and tag us on Instagram or send it to info@simplysoundless.com - Your design may be featured along with other great setups on our site.

@simplysoundless
#acousthex 
#simplysoundless